Delivery typically takes 3-10 days.Īirmail Tracked Letter and Airmail Tracked Parcel are for smaller items up to a value of £100. The World's Finest selection of Exotic Metalflake Finishes & the Choice of Custom Painting Professionals for Clarity, Depth of Color, Durability and Show-Stopping Brilliance.All of our products ship everywhere in mainland Europe.Īirmail Letter and Airmail Parcel are for smaller, lower priced items, with prices starting from £3.99. There is no comparison to our quality and service. We are the original manufacturer of metal flake finishes and the leader in producing high quality polyester flake used in a variety of industries.ĭon’t be fooled by knock off suppliers of metal flake products. Our products are the choice of professionals everywhere for clarity, depth of color, durability, and show stopping brilliance. Our metal flake products are the world’s finest selection of exotic polyester metallic flake and glitter. Do not re-coat-can cause wrinkling and/or lifting. Apply 3 coats of catalyzed Crysta-Crylor for "Wet Look", 3 coats of catalyzed Polygloss Clear, allowing 1 hour drying time between first two coats and 4 hours between Hand sanded to avoid sanding through to flake. After final coat allow 3 weeksĭrying time before sanding with #220 grit sand paper using an oscillating Allow to dry overnight, then wet-sand with #1000 grit paper, compoundĪcrylic to allow for sanding without exposing the flake (14-18 coats suggested)Īllow 10 minutes drying time between coati. After final coat, allowģ weeks drying time before sanding with #220 grit sand paper using an oscillating Suggested.) Allow 10 minutes drying time between coats. Blow off excess flake with air gun.Īcrylic to allow for sanding without exposing the Spindrift (14-18 coats Allow 20 minutes drying timeīetween each coat, rub surface lightly with bare hand between each coat toįlatten flakes standing on end. Use a Devilbiss #043 #30 or #306 nozzle or their equivalent to applyįlake coats (use 25 lbs. Alternate spray pattern with each coat to avoid streaking. Mix 4-5 ounces of Metalflake or Glowble toĪ quart of reduced (one-to-one) Clear Acrylic lacquer and apply 3 or more coatsĭepending upon the degree of coverage desired, alternating spraying direction withĮach coat Use 2 ball bearings in cup and hand agitate constantly to keep flake in Serve as a ground coat for the flake that will render any void spots from theĤ. Matches, as closely as possible, the color of the flake being used. Apply 3 coats of an Automotive Acrylic lacquer Metallic col0r that Allow 15 minutes drying timeĤ5 minutes after final coat, Sand with #360 grit paper.ģ. (A bleeder-sealer shouldīe used over all primers and other existing finishes.Ģ. We recommend removing finish down to original surface. Sand paper and apply a bleed sealer after applying a Primer-surfacer 0therwise WashĮxisting surface is a factory baked finish in good condition, scuff with #400 Is stripped bare, sand with oscillating sander using #180 grit paper.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |